Schatt and Morgan #69 Spear Blade Barlow Folding Knife

Delrin handles - Nickel silver bolsters with what appears to be a steel pin - not sure that schatt and morgan blades were put into anything but high quality handles, this was probably an old queen fra

Queen Cutlery, Schatt and Morgan English Barlow #97 Folding Knife - Stag handles - Schatt and Morgan Bolsters with the bottom of the M being overground - Queen DFC Spear Blade that the tip sits on top

Buffalo Horn Handles - Saber Ground Clip Blade - no wobble, good snap - Gap between liner/backspring - 4-7/8" long when shut

Stag Handles - Scrolled Inside Brass Liners - Good snap, no wobble - Blade off center - Center pin on mark side has been over ground - Gap between liner/backspring - No chips or cracks - 2-5/8" long w

Stag - blade off center slightly - small gap between liner/backspring - backspring is to short for the blade tang, blade sits back a bit and has play - good snap and half stop - 2-1/2" long when shut

Stag Handles - blade off center slightly and kick is overground so the blade sits low in the frame - light wobble, good snap, has blade rap - backspring where the spine meets the backspring it has bee

Stag Handles - Bolsters read BFC, MMIX - gap between scale and backspring - blade off center towards pile side - backspring low in closed position - no wobble, good snap

Stag handles - slightly off center blade - light wobble, good snap - slight blade rap on close - small gap between liners and backspring - Steel Bolsters - visible eye on the pins in bolster - 3-1/2"

Buffalo Horn Handles - slight gap at backspring/liner - Blade centered nicely - no wobble, good snap - Bolsters appear to be overground and you can see eyes from the pins

Jigged Delrin handles - Blade is centered, no wobble, great snap - can see eyes in the bolster - gap at liner/backspring - 3-1/2" long when shut

Kirinite Glow in the Dark Handles - Blade sits high in closed position - Snaps open well with little wobble - Closes if you hold the blade closed and push the lock bar over, it can snap open without t

Stag handles - light gap between backspring/liner - blade has some light wobble and front to back play when open - good snap, off center towards mark side when closed - 4-5/8" long when shut

Stag Handles - Blade centered well, has some blade rap - gap between spring/liner - no wobble, good snap - 3-3/4" long when shut

Ebony Scales - Wharncliffe Blade - D2 Steel - Blade is off center - No wobble, good snap - Gaps in liner and backspring

Amber Carved Bonestag, awesome pile side handles that does have a crack near center pin - main blade off center slightly - good snap, some light wobble - 4-1/2" long when shut - bolsters are fluted, e

Stag Handles - light wobble in open position, good half stop, kick is overground and the blade sits to low - slight gap in liner/backspring - a nice little knife - 2-5/8" long when shut

Stag - wobble on main blade and spine sits above backspring in open position - blades snap well - gap between liner and backspring - a nice little knife - 2-1/2" long when shut

Buffalo Horn handles - very light wobble, good snap, slightly off center clip blade - gap between liner/backspring - D2 Steel - 3-3/8" long when shut - pile side handle does have a light crack at the

2 Blade (Spear and Clip Blade) - Probably did not make production as there are eyes at the bolsters, slight gap in the liner/backspring area and you can see previous scratches of the grit on the backs

Count: 6 Dimensions: (Display case) H 2" x W 17.75" x D 13" Condition: No issues to note.

Queen Cutlery Cheetah #1L Lockback Folding Knife - Spear Blade - Centered but the blade sits a little low in the frame - Black Micarta? Handles - Tail sits a little high on the backspring - No wobble

Stag handles, thick pile side handles - backspring is high above liners when open position, Saber ground clip point dated 2009 - The knife is etched 2L but isn't a lockback version, could have been re

Stag handles, no chips or cracks - no wobble, good snap - can see bolster pin eyes on one side - probably a factory second - 2-5/8" long when shut

Stag Handles - Good snap, one with light wobble - Eyes show on one of the bolsters - 2-5/8" long when shut - no cracks or chips -