SCHATT MORGAN FOLDING KNIVES QUEENS CUTLERY

Count: 6 Dimensions: (Display case) H 2" x W 17.75" x D 13" Condition: No issues to note.

Queen Cutlery, Schatt and Morgan English Barlow #97 Folding Knife - Stag handles - Schatt and Morgan Bolsters with the bottom of the M being overground - Queen DFC Spear Blade that the tip sits on top

Delrin handles - Nickel silver bolsters with what appears to be a steel pin - not sure that schatt and morgan blades were put into anything but high quality handles, this was probably an old queen fra

Includes: -(5) Queen Cutlery knives: 1 of 100 #01 Traditional Pocket, #29 jack knife, (2) 3L Mountain Man, Schatt & Morgan Reversed Peanut -(1) Utica Cutlery Co: Trapper Largest: 3.75 In blade Con

Stag handles - Very Thick knife that is 3/4" thick overall - Lined Bolsters - no wobble, good snap - 3-7/8" long when shut

Stag Handles, very thick, 7/8" thick - blade sits a little low in the galley, may have some slight slight blade rap, I can't tell - Half stop isnt very crisp, no wobble - 3-3/4" long when shut

Moore Maker 5202 Trapper - Buffalo Horn Handles - Good Snap - No Wobble - Gap in liner and backspring - Blades are Centered - Brass Centerpin with Nickel Silver Scale Pins - Eyes are shown from the pi

Buffalo Horn Handles - Clip blade swedge grind on mark side has a small grind imperfection - no wobble, great half stop, good snap - blade centering is off to the mark side - small gap between liner a

Kirinite Glow in the Dark Handles - Blade sits high in closed position - Snaps open well with little wobble - Closes if you hold the blade closed and push the lock bar over, it can snap open without t

Stag handles - light gap between backspring/liner - blade has some light wobble and front to back play when open - good snap, off center towards mark side when closed - 4-5/8" long when shut

Buffalo Horn Handles - Saber Ground Clip Blade - no wobble, good snap - Gap between liner/backspring - 4-7/8" long when shut

Ebony Scales - Wharncliffe Blade - D2 Steel - Blade is off center - No wobble, good snap - Gaps in liner and backspring

Stag handles, thick pile side handles - backspring is high above liners when open position, Saber ground clip point dated 2009 - The knife is etched 2L but isn't a lockback version, could have been re

Stag handles, no chips or cracks - no wobble, good snap - can see bolster pin eyes on one side - probably a factory second - 2-5/8" long when shut

Stag Handles - light wobble in open position, good half stop, kick is overground and the blade sits to low - slight gap in liner/backspring - a nice little knife - 2-5/8" long when shut

Stag - wobble on main blade and spine sits above backspring in open position - blades snap well - gap between liner and backspring - a nice little knife - 2-1/2" long when shut

Wood Handles - Nickel Silver Bolsters - Blade Centered well, has slight blade rap - D2 Steel Blades - Gaps in liners/backsprings - 4-1/4" long when shut

Stag Handles - Blade centered well, has some blade rap - gap between spring/liner - no wobble, good snap - 3-3/4" long when shut

Stag Handles - Good snap, one with light wobble - Eyes show on one of the bolsters - 2-5/8" long when shut - no cracks or chips -

Amber Carved Bonestag, awesome pile side handles that does have a crack near center pin - main blade off center slightly - good snap, some light wobble - 4-1/2" long when shut - bolsters are fluted, e

Stag Handles - Scrolled Inside Brass Liners - Good snap, no wobble - Blade off center - Center pin on mark side has been over ground - Gap between liner/backspring - No chips or cracks - 2-5/8" long w

Simulated Stag - gap between liner/backspring - Brass shield - good snap - off center main blade

Amber Bonestag Handles - Brass Queen Shield - Blade is proud when closed, slightly off center - light wobble, great snap - 3-3/4" long when shut

Red Micarta Handles - good snap, light play when closed - 3-5/8" long when shut