Schatt and Morgan #31 Small Congress 4-Bladed Folding Knife

Stag Handles - Good snap, one with light wobble - Eyes show on one of the bolsters - 2-5/8" long when shut - no cracks or chips -

Stag handles, no chips or cracks - no wobble, good snap - can see bolster pin eyes on one side - probably a factory second - 2-5/8" long when shut

Torched Stag - no wobble, good snap - really nice knife

This is a Joe Pardue and Queen Collab - stag handles, the center pin doesn't look very good - tangs marked, Joe Pardue - D2 Steel - Good snap, good half stop, no wobble - gap between liner and backspr

Stag - wobble on main blade and spine sits above backspring in open position - blades snap well - gap between liner and backspring - a nice little knife - 2-1/2" long when shut

Stag Handles - Scrolled Inside Brass Liners - Good snap, no wobble - Blade off center - Center pin on mark side has been over ground - Gap between liner/backspring - No chips or cracks - 2-5/8" long w

Stag - blade off center slightly - small gap between liner/backspring - backspring is to short for the blade tang, blade sits back a bit and has play - good snap and half stop - 2-1/2" long when shut

Stag Handles - blade off center slightly and kick is overground so the blade sits low in the frame - light wobble, good snap, has blade rap - backspring where the spine meets the backspring it has bee

Stag handles - light gap between backspring/liner - blade has some light wobble and front to back play when open - good snap, off center towards mark side when closed - 4-5/8" long when shut

Buffalo Horn Handles - Saber Ground Clip Blade - no wobble, good snap - Gap between liner/backspring - 4-7/8" long when shut

Stag Handles - Blade centered well, has some blade rap - gap between spring/liner - no wobble, good snap - 3-3/4" long when shut

Amber Carved Bonestag, awesome pile side handles that does have a crack near center pin - main blade off center slightly - good snap, some light wobble - 4-1/2" long when shut - bolsters are fluted, e

Includes: -(5) Schatt & Morgan knives: Congress limited edition 1 of 600, Congress, Peanut, (2) Jack, Clip point folder -Longest: 4.5 In blade -Condition: all are excellent w/ boxes Provenance: A

Count: 6 Dimensions: (Display case) H 2" x W 17.75" x D 13" Condition: No issues to note.

Deer Hunter Congress 4 Blade Folding Pocket Knife; Like New Condition!

Kirinite Glow in the Dark Handles - Blade sits high in closed position - Snaps open well with little wobble - Closes if you hold the blade closed and push the lock bar over, it can snap open without t

Ebony Scales - Wharncliffe Blade - D2 Steel - Blade is off center - No wobble, good snap - Gaps in liner and backspring

Stag handles, thick pile side handles - backspring is high above liners when open position, Saber ground clip point dated 2009 - The knife is etched 2L but isn't a lockback version, could have been re

Stag Handles - light wobble in open position, good half stop, kick is overground and the blade sits to low - slight gap in liner/backspring - a nice little knife - 2-5/8" long when shut

Queen Cutlery, Schatt and Morgan English Barlow #97 Folding Knife - Stag handles - Schatt and Morgan Bolsters with the bottom of the M being overground - Queen DFC Spear Blade that the tip sits on top

Four heavy rolled-gold antique jewelry pieces are in this lot. They include a Victorian bar pin (2.25" long), a flower bud brooch (2.75" long), a buckle (2.25" long), and a small folding knife (4" lon

Schatt and Morgan #4L Small Mountain Man - Stag Handles - Blade Centered - Tail of the lockspring is sticking up over the liners and will catch on something - Light Snap - Has front to back wobble and

Delrin handles - Nickel silver bolsters with what appears to be a steel pin - not sure that schatt and morgan blades were put into anything but high quality handles, this was probably an old queen fra

Wood Handles, Mother of Pearl Keystone Shield - eyes showing on the bolster pin - knife does not have great snap - gap between liner and backspring - Great looking knife