32 Ford Flathead V8 Aluminum Oil Pan

Shows light wear and surface rust, one small crack is present on the top side, very good condition

Bell housing

Head, Offenhauser, for Ford Flathead V8, 1939-49 #1068 .400" relief, aluminum, Exc unused cond w/minor shelf wear, 19"L.

- Standard Oil Tanker Truck- Heavy Duty "Double Duty" rear axle - Powered by a Ford Flathead V8- 3 speed manual transmission- 16494 miles shown- 600 gallon 3 compartment oil tank- Truck runs and drive

Intake Manifold, Ford Flathead V-8 60 HP Edelbrock, 2 x 2 bbls, cast aluminum, Exc orig cond.

Intake Manifold, Ford Flathead, '49-53, Grancor 3x2 94's, aluminum, shows repair on front oil filler flange, o/wise Good cond, untested.

1932-1937 flathead Ford V8 with manual transmission and shifter having blown glass shift knob. The displacement is 221 cubic inches. The motor has been completely restored and is clean and ready to us

1932-1937 flathead Ford V8. The displacement is 221 cubic inches. The motor is very original and in as found condition on motor stand as found in the climate controlled garage of the current owner. Th

1932-1937 flathead Ford V8 with manual transmission and shifter. The displacement is 221 cubic inches. The motor is in very original condition as found in the climate controlled garage of the current

Engine, Ford Flathead V8 8RT6050B code. Likely rebuilt while in Larry's care. It does turn.

Malloroy distributor - Part #2571501

No shipping ! Bring proper help and equipment to load.

1/6 model of Henry Ford's 1st. V8 engine mounted and covered with a plexiglass case for display. In VG condition. 8.5"W x 6.5"D x 7"H

No shipping ! Bring proper help and equipment to load.

Shows light wear, very good to excellent condition, 24"x7.5"

Ardun Ford intake three carburetor manifold, the Ardun was hemi-spherical overhead valve conversion for the Ford flathead V8. It is one of the most desirable 1940Â’s-50Â’s speed equipment items

Five models all assembled '58 Pontiac, '59 Mercury, '58 Buick, '32 Ford V8 Coupe, '58 Chevy Impala, all who/B, 9 1/2" x 4 1/2" x 3"

Intake Manifold, '49-53 Ford Flathead, Grancor, aluminum, 2 x 2 bbl, Exc orig cond.

Heads (2), Ford Flathead, Fenton 1948-53, aluminum, VG orig used cond.

Heads (2), Ford Flathead 1939-48, Sharp, aluminum, VG cond w/one damaged lower fin.

1953 Ford V8 Flathead Engine & Transmission for display. Last year of production for the flathead after 21 years. Condition:For display only, Trans is good but motor will never run Shipping:Buyer to a

NO SHIPPING

Intake Manifold, new Ford Flathead 1948-53, single manifold, aluminum #C8BA-C8RT 6520 w/gear drive "slingshot" 2-carb adapter, has 97 Stromberg & clone carb, Exc cond, untested.

Heads (2), Ford Flathead, French Simca Vedette V-8 60 HP, 11218, Exc orig cond.