A Federal carved tilt top candle stand

A Federal Carved Mahogany Tilt-Top Candlestand North Shore, Massachusetts, Circa 1790 with ovoid top. Height 28 3/4 x width 17 3/4 x depth 22 1/2 inches. Provenance: Purchased at Christie's New York,

American Federal Carved Walnut Tilt-Top Candlestand , early 19th c., dished top, vasiform standard, spider legs, spade feet , h. 28 in., w. 19 1/8 in

Circa 1800, likely New England. The piece having a dish top above nicely carved and reeded base emitting three legs with pad feet. The block is replaced on this table. H26 1/2" W20" Sold from the coll

New York, 1810-1825, retains partial label. 29-1/2"h 26-3/4"w x 18-1/2"d

New York State or New England, 1815-1825. 28-1/2"h x 16-3/4"w x 24-1/4"d Provenance: The Stanley Weiss Collection Literature: www.stanleyweiss.com

A Federal Carved and Figured Mahogany Tilt-Top Candlestand Height 26 1/2 x diameter 16 3/4 inches. Property from the Historic Sword Gate House, Charleston, South Carolina

Federal Mahogany Carved Pedestal Base Tilt-Top Candlestand. 30"h. x 21-3/4"w. x 18"d. Condition: Good with wear.

A Federal Carved and Turned Mahogany Handkerchief Tilt-Top Candlestand New England, Circa 1800 Height 28 1/2 x width 22 x depth 21 1/2 inches.

A Late Federal Carved and Figured Mahogany Octagonal Tilt-Top Candlestand Circa 1810 Height 28 3/4 x width 19 3/4 x depth 28 inches. Property from a Private Chicago Collection

Federal Mahogany Tilt Top Candle Stand, having molded top on urn carved shaft, height 27 inches, top 16" x 13". Provenance: Estate of Peter Tillou, Litchfield, Connecticut.

with incurved corner top and flame birch oval inlay; notch carved column. Early 19th century. Size: 28 1/2" high, 17 3/4" wide, 15 1/2" deep. Estate found condition, cracking to refinished top, some s

Coffin shaped tilt top mahogany stand with curly maple inlaid center panel beaded outline inlays and a rosewood cross banded inlaid top, superior turned shaft with urn on spider legs ending in carved

Fine federal tilt top candle stand with inlaid top, heart design and shaped knees. School of Nathan Lombard. Nice old surface.

EARLY FEDERAL TILT TOP CANDLE STAND OVAL TIP SPIDER LEGS OLD CHERRY SURFACE

19th century American Federal tilt-top candle stand with turned pedestal, spider legs, and scalloped top, 28" H x 23 3/4" W x 17 1/2" L.

Cherry Federal tilt top candle stand, rectangular top with shaped corners, raised on tripod base with arched spider legs, American, early 19th c, 28-1/2" x 17" x 26-1/2"h

Cherry American Federal tilt top candle stand, oval top, hand wrought iron catch, over urn turned stand, over arched spider legs, top 21" x 14-1/2", 28-1/2"h, repaired break at top of one leg, circa 1

Federal tilt top candle stand, mahogany, ovoid single board top, ring turned column on three sabre legs. 27 3/4" h. c. 1800 - 1820. Condition: old repairs and refinished

Victorian Mahogany Carved Tilt Top Candle Stand: Turned pedestal, three cabriole legs, foliate knees. Measuring 26" x 22" top, 28" tall. 3 cracks glued on top, with slight warp.

First quarter 19th century, cherry. Octagonal top with inlaid foliate medallion. Turned column and three legs with scroll feet. Refinished with some surface scratches and edge loss, repair to block on

With cabriole legs and pad feet. Circa 1770-90, 16 3/8" wide, 25 1/4" long, 27 1/2" high CONDITION: No breaks. In good structural condition.

FEDERAL TILT-TOP CANDLESTANDNew England, Circa 1800In mahogany and cherry, with an octagonal top and three spider legs ending in spade feet.Height 29.25”. Top 23.75” x 18”.

MAHOGANY INLAID FEDERAL TILT TOP CANDLESTAND WITH SPIDER LEGS & CONCH SHELL INLAY (26" X 25" X 17 1/4")

FEDERAL TILT-TOP CANDLESTANDAmerica, First Quarter of the 19th CenturyIn mahogany. Lobed top. Turned pedestal supported by three reverse-arched molded legs.Height 27.75”. Top 27.5” x 18&#8