Machinist Lathe

Atlas Machinist's Lathe - Offered Without Reserve ---- ITEMS IS LOCATED IN FORT LAUDERDALE, FL ITEMS MUST BE PAID FOR AND REMOVED BY NOV. 11TH AT 3PM. ANY ITEMS LEFT AFTER NOV. 11TH WILL BE SHIPPED BY

Antique Occupational Shaving Mug Machinist Lathe Operator. LiveAuctioneers gives us up to 20 photos, to see many more photos of most lots find this sale on Proxibid, where we can post up to 100 images

Apprx 37" long. Getting all pictured in box. We did not take out of box to inspect. NO SHIPPING!

Approx 11" total length

Lot of 20 Lathe Cutting Bits and Cut off Blades

Lot of 20 Lathe Cutting Bits and Cut off Blades

Getting all pictured

Getting all pictured

Getting all pictured.

Very nice graphics of an early lathe on this Machinists mug. Marked D & O underneath. Light wear. 3 1/2" H, Excellent

Getting all pictured in box

Getting all pictured

TRAY LOT OF ASSORTED DRAFTING & MACHINIST TOOLS - Includes: Starrett No. 436 Micrometer; Starrett Lathe plunger dial test set in original box; Lufkin 1822 micrometer in box; Lufkin 1821 micrometer; Al

Cherry Roll Top Watch Makers Lathe Bench. Cherry roll top bench with 4 drawers, a single door and open compartment below, used condition and overcoated finish; measures 50 in. high x 28.25 in. wide x

30"x54"x21" Hamilton Manufacturing 30-drawer Machinist Chest -Drawer number 9 has been replaced with older drawer -BUYER MUST ARRANGE SHIPPING.

A Watchmakers Brass and Steel Mandrel Lathe and Gear Cutting Machine, 19th Century, Each unsigned. Mandrel Lathe: H: 6 1/2 x W: 18 x D: 7 in. Gear Cutter: H: 9 1/2 x W: 12 1/2 x D: 7 1/2 in. From the

No shipping ! Comes apart in approx 6 pieces. Bring help to take apart and remove. NO SHIPPING

This has an approx. 8" Swing

W.F. Barnes & John Barnes Co. No.4 Metal Lathe, approx. 34"x39"x44"H ---BUYER TO ARRANGE SHIPPING

American. 1920. Cast mounts with plated steel parts. Stamped, "Dalton New York U.S.A". 16 x 36 x 12". Mechanically functioning. CODE:TOOL

Louis Levin & Son, Santa Fe Springs, Ca., a watchmakers 8mm lathe with accessories, including a cross slide, milling attachment, tip over T rest, filing rest, collet holding tailstock, motor, backshaf

A turn of the century Boley & Leinen 6mm watchmaker's lathe. Steel body with Brass fittings, numerous attachments include a 6-jaw chuck, fixed and feeding tailstocks, center rest, sliding table, small

G. Boley, Germany, a nice plain bearing Geneva pattern lathe with box and accessories, including plain and lever feed collet holding tailstocks, 50 collets including wheel and ring chucks, offset driv

F.W. Derbyshire, Waltham, Mass., a good "Model 750" lathe with accessories, cast iron bed with 10 mm ball bearing headstock and lever feed 10mm collet holding tailstock, compound slide rest, tip over