Parts Cabinet with Hardware Eye Bolts Screws & Misc

Cabinet is approx. 12"x 30" x 14" tall. Cabinet is really loose and falling apart. Getting everything in it

Total dimensions stacked is approx 6 1/2" x 18" x 17 1/2" tall. NO SHIPPING

Cabinet is apprx 6 1/2" x 9 3/4" x 17" tall.

2 largest are apprx 5 3/4" x 12" x 22" tall. NO SHIPPING

Tallest cabinets 5 3/4" x 12" x 22" NO SHIPPING

Getting all pictured

Cabinet is approx 10" x 11 1/2" x 10" tall. Has some small creases in it

Nuts, Bolts, screws , nails, & misc hardware. 8 Boxes. Must take all

NO SHIPPING and must take all !

Parts cabinet is approx. 6" x 15" x 22". Has some copper & Brass in it, misc hardware. Also includes everything pictured on wall

THIS LOT DOES NOT INCLUDE THE 2 PARTS BINS, Workbench , Grinder, AND VISE THAT ARE SOLD SEPERATELY

FINE MULTI DRAWER CHESTNUT HARDWARE CABINET, 19/20TH C. H. 25" D. 23", SIGNED AMERICAN BOLT & SCREW CASE COMPANY DAYTON, OH DATED MAY 12, 1903

This room is filled. Tons of hardware, screws, nuts, bolts, chisels , oil cans, scrap iron. Take what you want and leave the rest

Hardware Store Display Cabinet, probably American Bolt and Screw Company, Dayton, Ohio, c. 1900. The upper case, which can be mounted to rotate, with ten stacked wedge-shaped drawers on each octagonal

Circa 1900 General Store Rotary Bolt & Screw Cabinet with 98 drawers. 80 drawers in upper part and 18 drawers in the base. Good working condition. Hgt 61" width 30" d 30" . Found in St Paul MN large V

An antique hardware store revolving nuts and bolts parts cabinet with an octagonal top, each side with ten numbered drawers on a square base with twelve drawers on two sides. White ceramic pulls. On c

72 DRAWER HARDWARE STORE COUNTER TOP PARTS CABINET, OR NUTS AND BOLTS, MISSING REVOLVING BASE, ALL DRAWERS AND KNOBS INTACT, STILL CAN SEE SOME OF THE OLD STENCILING & DECALS ON SOME OF THE DRAWERS, F

Misc nuts , bolts, nails, screws

Misc Lot incl Cable Zipper , 2 Large Staplers , Lots of Hardware incl Screws, nuts, bolts , etc

Complete contents of work bench in drawers and cabinets: Vintage auto tools and parts; nuts/ bolts and screws; auto advertising cans; auto tail lights; Solder wire and Soldering irons; Vintage pencil

This 19th Century Table Top model would have been use for bolts and screws in a hardware store. Phenomenal stenciling on the drawers. Rotates as if it was made today, yet it is over 100+ years old. Or

Getting all pictured on top of cabinets

Lot includes all pictured on top of cabinet. Does not include cabinet. Must take all and remove before Noon !

Bottom cabinet is approx 19 1/2" x 32" x 33" tall. Take what you want and leave the rest. Buyer to remove from basement. NO SHIPPING !