Atwater Kent Radio Breadboard w/ horn & Power

All metal Atwater Kent radio horn on a base with driver. In good condition but untested. Measures 25" tall, horn has a 14.75 inch bell.

No tubes.

Atwater Kent "Breadboard" Radio Receiver, 1922 Type 3, American 2-valve detector receiver (2 x UV-200), MW, battery, for loudspeaker, width 18 ½ in. Very good condition, original mounting. Radi

The 10C was introduced in the mid 1920s, it employed two stages of RF amplification and was the first successful AK radio employing condenser tuning. In overall very good condition, all tubes and knob

5 tubes. 31" x 10"

Type Ta amplifier. 5 tube.

All Metal. Measures approximately 21 inches tall by 13 inches.

All Metal. Measures approximately 19 inches tall by 11 inches.

Type TA. 2 tubes.

ATWATER KENT RADIO PHONOGRAPH LOUD SPEAKER HORN Phonograph radio "Model R" horn made in Philadelphia by the Atwater Kent Co. Horn size: 12" Size: 16"

ATWATER KENT RADIO PHONOGRAPH LOUD SPEAKER HORN Phonograph radio "Loud Speaker" made in Philadelphia by the Atwater Kent Co. Horn size: 14.5" Size: 24.5"

Atwater Kent Bread Board Radio Model AK12 TA, 34" Long 7.25" Tall

DESCRIPTION: 1923 Atwater Kent Model 10A breadboard radio. MEASUREMENTS: 31" wide. CONDITION: Light overall wear as expected with age and use.

11 1/4" w x 13" T metal frame circa 1928 - 30

1928 Kuprox A/V/AC Power Pack Model 206-X. 201 A tubes. Made by Codel Radio company. Atwater-Kent "B" Power Unit type R. Both good condition. Untested. See photos.

6-Tube radio housed in narrow wooden box, c. 1925 Dimensions: 19.00 " W x 6.25 " H x 6.25 "D; 

Atwater Kent broadcast receiver in metal case with brown plastic knobs, with type E speaker. c. 1926 Dimensions: : 17.00 " W x 5.25 " H x 7.25 "D; : 15.25 " W x 18.00 " H x 5.00 "D. Speaker fabric app

Sealed power unit, bathtub design with satin bronze-tone finish and goldtone accents 1928.

Vintage table radio by Atwater Kent, Model 47, black metal case w/removable lid, lid has a green painted panel w/emblem, serial #4511018, 8” T x 21” W x 10 ½” D AND a round speaker by A

A rare early radio 5-tube set; tubes are absent. Included speaker is an Atwater Kent type M loudspeaker with a large, heavy steel horn. Speaker has been tested using a modern audio amplifier connected

Untested. Approx. 17"w x 5" tall

Atwater Kent Model 92 cathedral tube radio, 19-1/4"H, 16"W, light up when plugged in, faint gravel noise.

Atwater Kent receiving set Model 30 radio, Serial No. 579743, 6 ½ inches high x 20 inches wide, and a metal horn speaker Model "H", 22 inches high.

Atwater Kent Model 20, 5 tube radio with cygnet style speaker.