1942-48 Malloroy Ford Flathead V8 Distributor

Malloroy distributor - Part #2571501

1932-1937 flathead Ford V8 with manual transmission and shifter having blown glass shift knob. The displacement is 221 cubic inches. The motor has been completely restored and is clean and ready to us

1932-1937 flathead Ford V8. The displacement is 221 cubic inches. The motor is very original and in as found condition on motor stand as found in the climate controlled garage of the current owner. Th

1932-1937 flathead Ford V8 with manual transmission and shifter. The displacement is 221 cubic inches. The motor is in very original condition as found in the climate controlled garage of the current

Engine, Ford Flathead V8 8RT6050B code. Likely rebuilt while in Larry's care. It does turn.

Shows light wear and surface rust, one small crack is present on the top side, very good condition

No shipping ! Bring proper help and equipment to load.

1/6 model of Henry Ford's 1st. V8 engine mounted and covered with a plexiglass case for display. In VG condition. 8.5"W x 6.5"D x 7"H

Intake Manifold, Ford Flathead V-8 60 HP Edelbrock, 2 x 2 bbls, cast aluminum, Exc orig cond.

No shipping ! Bring proper help and equipment to load.

Head, Offenhauser, for Ford Flathead V8, 1939-49 #1068 .400" relief, aluminum, Exc unused cond w/minor shelf wear, 19"L.

- Standard Oil Tanker Truck- Heavy Duty "Double Duty" rear axle - Powered by a Ford Flathead V8- 3 speed manual transmission- 16494 miles shown- 600 gallon 3 compartment oil tank- Truck runs and drive

Ardun Ford intake three carburetor manifold, the Ardun was hemi-spherical overhead valve conversion for the Ford flathead V8. It is one of the most desirable 1940Â’s-50Â’s speed equipment items

Intake Manifold, Edelbrock, for 1932-48 Ford Flathead w/4 Stromberg 97-2 bbl carbs, aluminum, Rare, Exc cond, untested.

Bell housing

1953 Ford V8 Flathead Engine & Transmission for display. Last year of production for the flathead after 21 years. Condition:For display only, Trans is good but motor will never run Shipping:Buyer to a

Heads (2), Ford Flathead, French Simca Vedette V-8 60 HP, 11218, Exc orig cond.

Heads (2), Ford Flathead 1939-48, Sharp, aluminum, VG cond w/one damaged lower fin.

Heads (2), Ford Flathead, 1932-48, mfgd by Fenton, aluminum, VG used cond.

RALLYE MONTE CARLO 1936, original photo album especially for participants, 12 B/W photos, 18x13cm, among others winner car Ford V8 model 48-2 (according to Cristea with fixed rear axle without differe

Ford Ardun and V8 flathead camshafts - both NOS and appear to be the same, will fit 59AB and 8BA blocks, specification sheet included

This is the first of four cars being offered from a local collection. This 1936 Ford Cabriolet is on an original '36 frame and has a flathead V8 motor. The body is the highest quality polyester body t

Restored condition, 239 flathead V8, 3 speed manual, no brakes currently, Ran and drove prior to sitting. No key, Florida title, 98RC324380

The darling of the Ford Expo at the 1939 World's Fair in New York, the new car sat on a 112" wheelbase, was powered by a 221 cubic inch flathead V8 that produced 90 horsepower. For most, it was love a